Headlamps, removing and installing: Removing
- Turn light switch to position "0".
CAUTION:
- Switch off all electrical consumers.
- Switch ignition off and remove ignition key.
Left headlamp
- Remove left engine cover - 1 -.
Right headlamp
- Remove applicable right engine cover - 1 -.
- Remove screws - arrows -.
- Remove Evaporative Emission (EVAP) Canister Purge Regulator Valve 1 N80 - 1 - at air duct.
- Remove air duct - 2 -.
Both sides, continued
- Use adhesive tape to mask area beneath headlamp to prevent damage to paintwork.
- Remove screws - 1 - and - 5 -.
- Loosen screws - 2 - and - 4 - (do not remove).
- Where applicable, remove cable tie.
- Disconnect electrical connection - 3 -.
- Remove headlamp from body towards front.