LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2009 >> A4 Base, 2D Convertible >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> Electrical Equipment >> 27 Battery, Starter, Generator, Cruise Control >> Battery >> Battery in luggage compartment, removing and installing

Battery in luggage compartment, removing and installing

CAUTION:
CAUTION: Before beginning repairs on the electrical system:
  • Where applicable, obtain anti-theft radio security code.
  • Switch off all electrical consumers.
  • Switch the ignition off and remove ignition key.
  • Disconnect negative ( - ) battery terminal.
  • After reconnecting vehicle battery, re-code and check operation of anti-theft radio. Also check operation of clock and power windows according to Repair Information and/or Owners Manual.

Removing 

Special tools, testers and auxiliary items required 

Fig 1: Identifying Torque Wrench V.A.G. 1331
GW00000113Courtesy of VOLKSWAGEN UNITED STATES, INC.
Fig 2: Removing/Install Battery From Battery Console Retaining Strip
GW00021566Courtesy of VOLKSWAGEN UNITED STATES, INC.
CAUTION: When disposing batteries it is absolutely necessary that the disposal procedures for batteries and sulfuric acid are observed.

Installing 

NOTE:
  • Only maintenance-free batteries conforming to standards "TL82506" (as of December 1997) and "VW75073" (as of August 2001) may be installed.
  • Batteries from the Audi Parts Program have a bottom strip-adapter for adapting to different grip channels. Whether and how bottom strip-adapter is used, refer to operating instructions for battery.
Fig 3: Identifying Battery Clamping Strip And Battery Holder Mount
GW00021567Courtesy of VOLKSWAGEN UNITED STATES, INC.
Fig 4: Removing/Install Battery From Battery Console Retaining Strip
GW00021566Courtesy of VOLKSWAGEN UNITED STATES, INC.

Reconnect battery in the following sequence with ignition and electrical equipment switched off:

The following steps are required after reconnecting battery:

NOTE:
  • When reconnecting battery, activate vehicle equipment (radio/radio navigation system, clock, electric window lifters) in accordance with Owners Manual.
  • Further measures after reconnecting the voltage supply refer to applicable engine repair information, .
  • Check proper function of remote control keys; adapt keys if necessary. Inform customer that all additional keys must also be adapted to ensure that the remote control works properly Owners Manual.
  • After re-connecting battery, the ESP indicator lamp will go out only after driving a distance of several meters.

Tightening torques 

Component - fastener Nm
Battery hold-down bracket - nut 12
Battery terminal to battery post - nut 7.5