Front 3-point seat belt with belt tensioner, assembly overivew: Notes
1 - Belt guide
2 - Belt
3 - Latch plate
4 - Belt reel/belt tensioner
- Removing
CAUTION:
Observe the necessary measures when disconnecting battery. →
- 27 BATTERY, STARTER, GENERATOR, CRUISE CONTROL
- 27 BATTERY, STARTER, GENERATOR, CRUISE CONTROL for ELECTRICAL EQUIPMENT, CABRIOLET
- Disconnect battery.
- Remove rear bench seat → Rear seat bench, assembly overview .
- Remove rear seat backrest → Rear seat backrest, assembly overview .
- Remove side trim → Rear side trim, assembly overview .
- Remove bolt - 5 -.
- Disconnect belt tensioner connector Disconnecting connector for front seat belt tensioner .
- Remove anchorage point for outer floor panel - 6 - → Front anchorage point for outer floor panel .
- Unclip belt guide - 1 -.
- Pull belt - 2 - out of guide - 1 -.
- Remove belt reel - 4 -.
- Installing
- Install front seat belt in reverse order of removal.
5 - Bolt
- Tightening torque 55 Nm
6 - Anchorage point: Outer floor panel