Child-seat restraint function for additional child seats (not for drivers seat belt), checking
- The complete belt assembly (including side panel trim) must be installed when checking this function.
- Activation of restraint function:
- Pull out webbing as far as possible.
- Correct function:
- The belt should retract with an audible noise.
- If the belt retraction is stopped, it should not be possible to pull the belt out again until the function is deactivated.
- Deactivation:
- Allow the belt to retract as far as the last 100 mm (approx.).
- Restraint function must be deactivated at the latest when the last 100 mm are reached. The belt then re-assumes its normal function.