Brake Shoes &/Or Pads: Remove & Replace
WARNING: This page is about the A3 Base, 2.0 E, Automatic DCT, which is a different variant/trim than selected.
Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable).
Includes: Repack Wheel Bearings (where applicable).
DOES NOT include refinishing.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| All | 1.8 | B | ||
| Front | 1.0 | B | ||
| Rear | 1.0 | B | ||
| Combination Procedure: BRAKE HOSE: Replace: Includes: Bleed Brake System. | ||||
| Each Additional | 0.2 | B | ||
| One | 0.4 | B | ||
| Combination Procedure: CALIPER: Replace: Includes: Bleed Brake System. | ||||
| One | 0.4 | B | ||
| Combination Procedure: DISC ROTOR: Remove and Install for Refinishing: This operation does not apply to drive axles. If on vehicle refinishing is not possible use appropriate repair operation. Includes: Pack Bearings (where applicable). | ||||
| Each | 0.1 | B | ||
| Combination Procedure: DISC ROTOR: Replace: | ||||
| Each,Front | 0.1 | B | ||
| Each,Rear | 0.1 | B | ||
| Combination Procedure: WHEEL BEARING: Replace: Includes: Pack Bearings (where applicable). | ||||
| FWD, Rear,One Side | 0.6 | B | ||
| Front,One Side | 0.6 | B | ||