Speed sensor on rear axle, removing and installing

Removing 

• Raise vehicle.

Fig 1: Identifying Speed Sensor Wiring Connector, And Bolt

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Separate speed sensor and speed sensor wiring connector - 1  -.
• Remove bolt - 2  - from wheel bearing housing.
• Remove ABS speed sensor from wheel bearing housing.

Installing 

• Before inserting speed sensor, clean hole inner surface and coat speed sensor all-round with Polycarbamide grease G 000 650 
• Insert speed sensor into hole in wheel bearing housing and tighten bolt together with retainer for speed sensor harness to 10 Nm.
• Connect speed sensor to speed sensor wiring.