Side marker lamp, removing and installing

Fig 1: Identifying Quick-Release Screws And Front Noise Insulation

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Removing 

• Switch ignition off and remove ignition key.
• Turn light switch into "0" position.
• Remove quick-release screws - 1  - and - 2  - and remove front noise insulation.

Fig 2: Identifying Clip, Side Marker Lamp, And Bulb Socket

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Press clip - 1  - in - direction of arrow  - using a screwdriver.
• Remove side marker lamp - 2  - toward front out of bumper cover.
• Remove housing for side marker lamp from bulb socket - 3  -.

Installing 

Installation is performed in reverse order of removal, noting the following:

• After installing side marker lamp, press clip toward outside of vehicle into bumper cover using a screwdriver.