Active Steering Control Module -J792-, REMOVING AND INSTALLING: Installing: Notes

Fig 1: Disengage Carpet And Support It Using A Suitable Block Of Wood

Courtesy of AUDI OF AMERICA, LLC

Installation is the reverse of removal, with special attention to the following: 

Follow the sequence when installing the control module:

-- Tighten the bracket -4- with the bolts -5- to the control module -8- to 8 Nm.

-- Connect the wiring harness connectors -3- to the control module -8-.

-- Carefully slide the wiring harness clip connection -3- into the bracket -4-.

-- Insert the control module with the bracket.

-- Connect the ground wire -2- to the threaded pin and tighten the nuts -1- to 6 Nm.

-- Tighten the nuts -7- to 6 Nm.

-- The system must be calibrated if the Active Steering Control Module -J792-. Refer to DYNAMIC STEERING BASIC SETTING .