Rear Axle Toe, Adjusting

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools And Workshop Equipment Required

Ring spanner insert AF 21:T40183
No illustration, commercially available pawl with fine gear

-- Remove the nut -A- of threaded connection tie rod/subframe, and screw on new nut until stop.

Fig 1: Identifying Nut On Threaded Connection Tie Rod/Subframe

Courtesy of AUDI OF AMERICA, LLC

-- Adjust toe by turning eccentric bolt -B-.

Wheel alignment specified values, refer to WHEEL ALIGNMENT SPECIFIED VALUES .

-- Tighten the nut -A- using the :T40183 (95 Nm).

-- After tightening nut -A-, check toe value once more. Refer to WHEEL ALIGNMENT SPECIFIED VALUES .

NOTE:

The maximum adjustment range is 90° to left or right of center position.

The geometric drive axle is automatically changed when individual toe settings are changed.