Dynamic Steering Overview
WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Additional information on dynamic steering can be found in Self Study Program No. 402 Audi Dynamic Steering.
- Power Steering Pump
- with an electric control valve
- The control valve is only installed on vehicles with 6- and 8-cylinder engines.
- The power steering pump and control valve are one component and are replaced together.
- Installation location in vehicles with 4 and 6-cylinder engines: On the front left of the engine (belt drive).
- Installed location on vehicles with an 8-cylinder engine: Installed on the back of the engine on the left side (chain drive).
- Actuator
- Must not be loosened or removed from the steering column.
- The actuator and steering column are one component and are replaced together.
- The system must be calibrated if the actuator is replaced. Refer to DYNAMIC STEERING BASIC SETTING .
- Removing and installing, refer to STEERING COLUMN .
- Active Steering Control Module -J792-
- The system must be calibrated if the active steering control module -J792- is replaced. Refer to DYNAMIC STEERING BASIC SETTING .
- Removing and installing, refer to Level Control System Control Module -J792- .