LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2008 >> Q7 4.2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 49 (3.0L - Cylinder Head & VALVETRAIN - Engine Code(S): CJTB, CJTC, CNAA, CJWB, CJWC, CJWE, CTWA, CTWB) >> 15 Cylinder Head, VALVETRAIN >> Cylinder Head >> Left Cylinder Head Cover, Removing And Installing >> Installing

Left Cylinder Head Cover, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2012 Audi Q7, and 2011 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the O-ring.

Replace the cylinder head seal if it is damaged.

Replace the cylinder head cover bolts when replacing the damaged seal.

-- Clean the sealing surfaces; they must be free of oil and grease.

-- Tighten the left cylinder head cover bolts. Refer to Figure.

-- Install the ignition coil. Refer to IGNITION COILS WITH POWER OUTPUT STAGES, REMOVING AND INSTALLING .

scientia non olet · About LEMON Manuals