Rain/Light Recognition Sensor -G397-, REPLACING: Removing
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2012 Audi Q7, and 2011 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the interior rearview mirror, refer to Interior Equipment .
-- Disconnect the connector.
-- Release the retaining tab -arrows- with a small screwdriver.
-- Remove the retaining clip -2- from the mounting plate -1-.
-- Wait one minute so that the silicon pad can release without leaving any residue.
-- Loosen the Rain/Light Recognition Sensor -G397- item -3- by moving it back and forth and remove it from the mount.
-- Remove the silicon pad from the windshield, leaving no residue.
-- Clean the adhesive surface on the windshield with Cleaning Solution D 009 401 04.
- Any silicone residue must be completely removed.