Rubber Seal, Removing And Installing
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2012 Audi Q7, and 2011 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
Removal
-- Remove the windshield wiper motor, refer to Rear Window Wiper Motor -V12-, REMOVING AND INSTALLING .
-- Pry the rubber seal carefully out of the rear window.
Installation
Install in reverse order of removal. Note the following:
-- Install the rubber seal -2- into the rear window -1-.
- The marking -3- must face upward.
-- Install the windshield wiper motor, refer to Rear Window Wiper Motor -V12-, REMOVING AND INSTALLING .