Shaft Seals, Rear Final Drive 0BN And 0BP Overview

WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2012 Audi Q7, and 2011 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Final Drive Shaft Seals Components Location

Courtesy of AUDI OF AMERICA, LLC

Sealing Plugs
- Install with Locking FluidAMV 185 101 A1
- Replace
- 35 Nm
Front Final Drive
Bonded Rubber Bushing on the Front Housing
- Removing and Installing. Refer to BONDED RUBBER BUSHING IN FRONT HOUSING, REMOVING AND INSTALLING .
Locking Ring
- Replace after removing
Shaft Seal
- For the right flange shaft
- Replacing. Refer to RIGHT FLANGE SHAFT SEAL, REPLACING .
Ring
Right Flange Shaft
Bleeder
Bleeder
Bonded Rubber Bushing on the Flange/Driveshaft
- Removing and Installing. Refer to BONDED RUBBER BUSHING, FLANGE SHAFT AND DRIVEHAFT, REMOVING AND INSTALLING .
Ring
Locking Ring
- Replace after removing
O-Ring
- Replace after removing
Shaft Seal
- For the flange/Driveshaft
- Replacing. Refer to SEAL FOR FLANGE/DRIVESHAFT ON FRONT FINAL DRIVE, REPLACING (FINAL DRIVE REMOVED) .
Bonded Rubber Bushing on the Left Housing
- Removing and Installing. Refer to BONDED RUBBER BUSHING ON LEFT HOUSING, REMOVING AND INSTALLING .
Left Flange Shaft
Ring
Shaft Seal
- For the left flange shaft.
- Replacing. Refer to LEFT FLANGE SHAFT SEAL, REMOVING AND INSTALLING .
Needle Bearing
- Replacing. Refer to LEFT FLANGE SHAFT NEEDLE BEARING, REPLACING .
Locking Ring
- Replace after removing.