Bar Piece, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2012 Audi Q7, and 2011 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
-- Before installing bar piece -1-, ensure clip -arrow A- is inserted in body.
-- Slide the bar piece at an angle from below onto upper A-pillar trim -2-.
-- Clip the bar piece with the tab -arrow B- into the clamp -arrow A- and at the same time with the locking mechanisms -arrow C- into lower A-pillar trim -3-.
NOTE:
Ensure bar piece -1- is held securely.
-- Draw door seal lip over bar piece.