Sun Visor, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2012 Audi Q7, and 2011 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
-- Disengage sun visor (rear sun visors on vehicles with double sun visor) in vehicle center at sun visor center bearing and fold it to side.
-- Unclip sun visor center bearing cover with a small screwdriver and remove screw.
-- Carefully unclip cover cap -3- with Trim Removal Wedge3409.
-- Remove screws -arrow A- and -arrow B-.
-- Loosen sun visor -1- and -2- on vehicles with double sun visor from roof crossmember.
-- Remove the affected A-pillar trim.
-- Remove the rear grab handle. Refer to ROOF GRAB HANDLE, REMOVING AND INSTALLING .
-- Carefully lower the headliner and disconnect the visor from wiring harness.