Screen Separator Wall Mount, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2012 Audi Q7, and 2011 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Pressing Cap -1- Toward Outside Of Vehicle To Unscrew Underlying Bolt -3-

Courtesy of AUDI OF AMERICA, LLC

-- Unclip screen separator wall mount cover -2- with the Trim Removal Wedge3409.

NOTE:

Cover -2- is connected to the headliner via a limiting strap.

To replace cover -2-, thread the limiting strap out of the cover.

-- Move cover cap -1- to the side and remove screw -3- on screen separating wall mount -4-.

-- Remove mount from headliner and body.

NOTE:

Threaded screw holes -3- must always be cleaned (for example, with thread cutter)

If threaded hole is not cleaned, there is the danger that the new screw could seize up during installation and shear off when removed again.