LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2008 >> Q7 4.2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Interior Trim) >> 70 Interior Trim >> Roof Trim >> Roof Grab Handle, Removing And Installing >> Installing

Roof Grab Handle, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2012 Audi Q7, and 2011 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Observe the following when doing so:

Rear roof grab handle is equipped with a coat hook.

NOTE:

Threaded holes for roof grab handle must be cleaned of locking compound residue after removal. Otherwise, new screws could lock up when installed and shear off when removed again.

They can be cleaned with a thread cutter.

Replace roof grab handle screws (self-locking).

scientia non olet · About LEMON Manuals