LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2008 >> Q7 4.2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (3.0L - Diesel Fuel Injection - Engine Code: CATA) >> 23 Diesel Fuel Injection >> Intake Manifold >> Intake Manifold Upper Section, Removing And Installing >> Installing

Intake Manifold Upper Section, Removing And Installing: Installing

WARNING: This page is about a different car, the 2011 Audi Q7, 2010 Audi Q7, and 2009 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Always replace gaskets and seals.

Hose connections and charge air system hoses must be free of oil and grease before installing.

Make sure the intake ducting is not blocked by leaves or dirt; clean if necessary.

Secure all hose connections using hose clamps appropriate for the model type. .

scientia non olet · About LEMON Manuals