Complete the Adjustment:

WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, and 2013 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Bolts 1, 2 And 3

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the bolts -1, 2 and 3- to 10 Nm.

-- Press the v button -4- to continue.

Fig 2: Identifying Electronic Unit (E-Box)

Courtesy of AUDI OF AMERICA, LLC

Select on the Tester for E-Positioner - E-Box VAS6395B/1 display:

X, XXX V
[OK]

-- Remove the Turbo E-Positioner Service Kit - Bracket VAS6395/6 -arrow-.

Fig 3: Identifying Bracket VAS 6395/6

Courtesy of AUDI OF AMERICA, LLC

-- Press the v button -4- to continue.

Fig 4: Identifying Electronic Unit (E-Box)

Courtesy of AUDI OF AMERICA, LLC

The Turbocharger Control Module 1 -J724- goes to the end points.

NOTE:

If "FAULT" appears in the display, then replace the new Turbocharger Control Module 1 -J724-. Refer to Install the new Turbocharger Control Module 1 -J724- .

Select on the Tester for E-Positioner - E-Box VAS6395B/1 display:

[OK]

The adjustment is complete.

-- Disconnect the connectors for the Tester for E-Positioner - E-Box VAS6395B/1.

Continue with Assembly.