Regulator Valve, Removing And Installing, 6.0L (V12): Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2011 Audi Q7, and 2010 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

Tightening specifications, refer to REGULATOR VALVE, REMOVING AND INSTALLING, 6.0L (V12) .

NOTE:

Secure all hose connections with spring-type clamps appropriate for the model.

During installation, the cable ties must be installed at the same location.

-- Connect the hoses according to the marking making sure they are twisted.

The location of the fuel hoses and the flow direction are marked on the regulator valve with "VL" or "RL".

-- Bleed the fuel system, refer to FUEL SYSTEM, BLEEDING .