Overview - Fuel Tank, Vehicles With 6.0L (V12) Engine
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2011 Audi Q7, and 2010 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
- Fuel supply line
- To the metering pump for the auxiliary heater
- Clipped in on fuel tank
- Fuel Return Line
- from the fuel system cooler
- Clipped in on fuel tank
- Connector couplings, disconnecting, refer to CONNECTOR COUPLINGS, SEPARATING .
- Fuel supply line
- To the regulator valve
- Clipped in on fuel tank
- Connector couplings, disconnecting, refer to CONNECTOR COUPLINGS, SEPARATING .
- Bolt
- Tightening sequence Installing
- 33 Nm
- Mounting strap
- front right
- Pay attention to the installed position.
- Bolt
- Tightening sequence Installing
- 33 Nm
- Mounting strap
- rear right
- Pay attention to the installed position.
- Nut
- 9 Nm
- Shield
- for fuel filler tube
- Bolt
- 9 Nm
- Overflow Hose
- Rubber Gasket
- Cap
- Attached to the fuel filler door insert with an permanent fastener
- Bolt
- 5 Nm
- Ground Connection
- For discharging electrostatic charge
- make sure the connector fits securely on the fuel filler tube metal ring
- After installing, check electrical connection of fuel filler tube to a bare area of chassis using Ohm meter - Specified value: approximately 0 Ω
- Bolt
- 9 Nm
- Bracket
- For breather line
- Carrier Plate
- Bolt
- Tightening sequence Installing
- 33 Nm
- Fuel Tank
- With heat shield
- Removing and installing, refer to FUEL TANK, REMOVING AND INSTALLING, 6.0L (V12) ENGINE .
- Mounting strap
- Rear left
- Pay attention to the installed position.
- Bolt
- Tightening sequence Installing
- 33 Nm
- Bolt
- Tightening sequence Installing
- 33 Nm
- Mounting strap
- Front left
- Pay attention to the installed position.
-- Route the ground connection -1- as shown.
-- Ensure connector of Ground (GND) connection fits securely at metal ring of fuel filler tube.
NOTE:
Ignore -items 2 and 3-.
WARNING:
Danger due to electrostatic charge.
- After installing, check electrical connection on fuel filler neck metal ring to an empty spot on the body using an Ohm meter.
- Specified value: approximately 0 Ω.