Right Suction Jet Pump, Removing And Installing, Vehicles With 3.0L (V6)/4.2L (V8) Engines Through 05/2010: Removing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2011 Audi Q7, and 2010 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Follow all safety precautions, refer to WORKING ON FUEL SYSTEM .

Follow the guidelines for clean working conditions, refer to CLEAN WORKING CONDITIONS .

To remove suction jet pump, fuel tank should be completely empty. Procedure to empty the fuel tank, refer to FUEL TANK, DRAINING .

-- Remove the right fuel delivery unit, refer to RIGHT FUEL DELIVERY UNIT AND Transfer Fuel Pump -G6-, REMOVING AND INSTALLING .

Fig 1: Identifying Removal Of Fuel Level Sensor Through Guide -Arrow 2- While Pressing Locking Tab -Arrow 1-

Courtesy of AUDI OF AMERICA, LLC

-- Reach into the right fuel tank opening and remove the Fuel Level Sensor -G- from the guide in direction of -arrow 2- while pressing the locking tab in direction of -arrow 1-.

-- Carefully remove the Fuel Level Sensor -G- through the opening in the fuel tank.

NOTE:

The Fuel Level Sensor -G- is shown without the fuel tank to provide a better illustration.

-- Reach through the opening on the left side of the fuel tank, press the releases and remove the delivery line -1-.

Fig 2: Fuel Delivery Unit Lines Location

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore items -2, 3 and 4-.

-- Reach through the opening in the fuel tank and pull the delivery line out through the opening on the right side of the fuel tank.

Fig 3: Removing Suction Jet Pump

Courtesy of AUDI OF AMERICA, LLC

-- Press the tab -arrow 1- and pull the suction jet pump out of the guide in direction of -arrow 2-.

NOTE:

The suction jet pump is illustrated without the fuel tank.

-- Remove suction jet pump carefully through the opening in the fuel tank.