Right Suction Jet Pump, Removing And Installing, Vehicles With 3.0L (V6)/4.2L (V8) Engines Through 05/2010: Installing

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2011 Audi Q7, and 2010 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace seals.

Verify that the suction jet pump is securely engaged.

-- Install the right suction jet pump into the guide and push on it until it clicks.

-- Push the delivery line through the opening on the right side of the fuel tank and into the left fuel tank chamber.

-- Reach through the opening on the left side of the fuel tank and install the delivery line -1- on the fuel delivery unit until it clicks.

Fig 1: Fuel Delivery Unit Lines Location

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore items -2, 3 and 4-.

-- Before installing, check the routing of the wires on the Fuel Level Sensor -G-.

Fig 2: Fuel Level Sensor Tabs Location

Courtesy of AUDI OF AMERICA, LLC

-- The wire must be clipped into the tabs -arrows- as illustrated.

-- Insert the Fuel Level Sensor -G- into the guide and press it down until it clicks into place.

-- Install the right fuel delivery unit, refer to Installing .