LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2008 >> Q7 4.2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (3.0L - Cooling System - Engine Code(S): CJTB, CJTC, CNAA, CJWB, CJWC, CJWE, CTWA, CTWB) >> 19 Cooling System >> Coolant Pump And Thermostat >> Coolant Thermostat, Removing And Installing >> Installing

Coolant Thermostat, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2012 Audi Q7, and 2011 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

When removing and installing the coolant thermostat, make sure that the thermostat needle is installed correctly (conical end is inserted in the coolant thermostat wax thermostatic element). If necessary, push the thermostat needle all the way into the wax thermostatic element.

NOTE:

Replace the seal.

-- Install front coolant pipe. Refer to FRONT COOLANT PIPE, REMOVING AND INSTALLING .

-- Install the supercharger. Refer to SUPERCHARGER, REMOVING AND INSTALLING .

-- Fill with coolant. Refer to COOLANT, DRAINING AND FILLING .

scientia non olet · About LEMON Manuals