Right Coolant Pipe On Transmission, Removing And Installing: Removing

Fig 1: Identifying Generator Removal

Courtesy of AUDI OF AMERICA, LLC

-- Drain the coolant. Refer to COOLANT, DRAINING AND FILLING .

-- Remove the right front wheel. Refer to WHEEL, CHANGING AND MOUNTING .

-- Remove the generator. Refer to GENERATOR, REMOVING AND INSTALLING .

-- Remove the vacuum hose -1- from the air guide pipe connection.

Fig 2: Identifying Air Guide Pipe And Clamps

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the clamps -arrows- and remove the air guide pipe.

-- Remove the bolt -1- from the right coolant pipe on the transmission.

-- Loosen the hose clamp -2-.

-- Remove the right engine mount. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .

Fig 3: Identifying Right Coolant Pipe On The Transmission Bolt And Hose Clamp -2-

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -3-.

-- Press the release buttons and remove the secondary air hoses -1-.

-- Remove the nuts -2- and loosen the nut -5-.

-- Remove the Secondary Air Injection Pump Motor -V101- and bracket.

Fig 4: Component Location Of AIR Pump Motor -V101-

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -2- for the Ground (GND) cable on the right longitudinal member.

Fig 5: Ground Connection On Right Longitudinal Member

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows- and remove the right engine support -1-.

Fig 6: Identifying Right Engine Support -1- And Bolts -Arrows-

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -4-.

-- Remove the nuts -1 and 3- and free up the B+ wire on the starter.

Fig 7: Identifying B+ Wire On Starter Nuts

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1- from the right coolant pipe on the transmission.

-- Remove the bolt -2- from the ATF pipe.

-- Free up the wiring harness and remove the right coolant pipe from the transmission

Fig 8: Identifying Right Coolant Pipe Bolts -1- And ATF Bolt -2-

Courtesy of AUDI OF AMERICA, LLC