LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2008 >> Q7 4.2 >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (3.0L - Cooling System - Engine Code(S): CJTB, CJTC, CNAA, CJWB, CJWC, CJWE, CTWA, CTWB) >> 19 Cooling System >> COOLANT PIPE AND After-Run Coolant Pump -V51- >> Engine Coolant Temperature Sensor -G62-, REMOVING AND INSTALLING >> Installing

Engine Coolant Temperature Sensor -G62-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2012 Audi Q7, and 2011 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the O-ring.

To prevent loosing coolant, install the new Engine Coolant Temperature Sensor -G62- right away into the front coolant pipe.

-- Check the coolant level. Refer to COOLANT, DRAINING AND FILLING .

scientia non olet · About LEMON Manuals