Supercharger, Securing To Engine/Transmission Holder For Leakage Test
WARNING: This page is about a different car, the 2015 Audi Q7, 2014 Audi Q7, 2013 Audi Q7, 2012 Audi Q7, and 2011 Audi Q7. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The seals on the Gearbox Support Supplement T40206/2 should seal off the openings inside the supercharger housing during the leakage test.
Special tools and workshop equipment required
- Engine And Transmission Holder VAS6095
- Gearbox Support T40206 with T40206/1 and Gearbox Support Supplement T40206/2
Procedure
- Supercharger removed. Refer to SUPERCHARGER, REMOVING AND INSTALLING .
-- Install the Gearbox Support T40206 with T40206/1 in the Engine And Transmission Holder VAS6095.
-- Secure the supercharger to the transmission holder as illustrated. Use the holes "1", "4", "9", "11" and "13" for the threaded connectors -1-.
-- Attach the Gearbox Support Supplement T40206/2 directly to the supercharger housing at the front and on the right side using the bolt -2-.
Installation position of the Gearbox Support Supplement T40206/2:
- The seals on the support seal off the openings inside the supercharger housing.