Cooling Led, Removing And Installing

Procedure

Fig 1: Pushing Retaining Spring -2- To Side -Arrow- To Remove LED -3-

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Cooler -J698-. Refer to Cooler -J698-, REMOVING AND INSTALLING .

-- Free up the switch wiring harness.

-- Disconnect the wires -1, 4 and 5- on the switch.

-- Carefully push the retaining spring -2- to the side -arrow- and remove the LED -3-.

-- Disconnect the wire and connect the new LED wire, repairing a 0.25 mm ² wire.

-- Install the LED until it clicks.

-- Install the Cooler -J698-. Refer to Installing .