Roof Grab Handle, Removing and Installing

Special tools, testers and auxiliary items required

Fig 1: Torque Wrench V.A.G 1783

GW00000180

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Torque wrench V.A.G 1783

Removing

Fig 2: Roof Grab Handle, Bolts & Covers

GW00030176

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Using a screwdriver, pry out covers - 3 - (2x) from below.
Remove bolts - 2 - (qty. 2).

Tightening torque 4 Nm.

Remove roof grab handle - 1 -.

Installing

NOTE:

Threaded holes for roof grab handle must be cleaned of locking compound residue after removal. Otherwise, new screws could lock up when installed and shear off when removed again.
They can be cleaned with a thread cutter.
Replace roof grab handle screws (self-locking).