Rear parking aid sensors, removing and installing

Fig 1: Identifying Component Location In Bumper

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Component location: In bumper - arrows  -.

Fig 2: Identifying Bolts

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Removing 

• Remove bolts - arrows  -.

Fig 3: Identifying Electrical Harness Connector, Catches, And Sensor

Courtesy of VOLKSWAGEN UNITED STATES, INC.

• Reach behind bumper cover.
• Disconnect electrical harness connector - 1  - at sensor.
• Push both catches aside - arrows  - and press sensor - 2  - through from outside toward inside.

Installing 

Installation is performed in reverse order of removal, noting the following:

• Install rear bumper cover → 63 - Bumpers Removal And Installation .

Tightening torque