Front parking aid sensors, removing and installing

Fig 1: Identifying Component Location In Bumper

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Component location: In bumper - arrows -.

Removing

Inner sensor:

Fig 2: Releasing Clip Using A Screwdriver And Removing Air Inlet Grille At Lower Part Of Bumper Cover

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Outer sensor - vehicles with gasoline engine:

Release clip using a screwdriver - arrow A - and remove air inlet grille - 1 - at lower part of bumper cover - arrows B -.

Outer sensor - vehicles with 10-cyl. engine:

Fig 3: Identifying Electrical Harness Connector, Catches, And Sensor

Courtesy of VOLKSWAGEN UNITED STATES, INC.

All:

Disconnect electrical harness connector - 1 - at sensor.
Push both catches aside - arrows - and press sensor - 2 - through from outside toward inside.

Installing

Installation is performed in reverse order of removal, noting the following: