| Hood |
| Ball head pin to hood |
- |
14 |
| Hood catch to hood cap nut |
- |
11 |
| Hood hinge to body bolt |
- |
21 |
| Hood hinge to hood nut |
- |
21 |
| Lower part of hood lock to lock carrier bolt |
- |
14 |
| Rear Lid, Avant |
| Adjusting buffer to fender bolt |
- |
8 |
| Ball head pin to rear lid |
- |
20 |
| Rear lid hinge to body nut |
- |
21 |
| Rear lid hinge to rear lid bolt |
- |
21 |
| Rear lid lock to rear lid nut |
- |
21 |
| Rear lid catch to body nut |
- |
21 |
| Rear lid left drive unit to bracket bolt |
- |
8 |
| Rear lid left drive unit to hinge arm 1 |
| - Bolt |
- |
8 |
| - Bolt |
- |
12 |
| Rear lid left drive unit bracket to rear lid bolt |
- |
21 |
| Rear lid drive motor 1 |
| - Bolt |
- |
8 |
| - Bolt |
- |
12 |
| Rear lid drive motor to lid hinge nut |
- |
6 |
| Securing piece to rear lid grip piece nut |
- |
8 |
| Stop to hood bolt |
- |
8 |
| Rear Lid, Sedan |
| Cover to cylinder lock bolt |
- |
5 |
| Cover plate to rear lid nut |
- |
5 |
| Handle to rear lid bolt |
- |
8 |
| Lock cylinder to rear lid bolt |
- |
8 |
| Rear lid hinge to body bolt/nut |
- |
21 |
| Rear lid lock nut |
- |
8 |
| Striker pin bolt |
- |
8 |
- 1
Tightening specification for the self-tapping bolt that is installed in both fork halves: 12 Nm. Tightening specification for the self-tapping bolt that is installed in only one fork half: 8 Nm.
|