Front ashtray light, removing and installing
Removing
- On vehicles with automatic transmission, place selector lever in position "S".
CAUTION:
- Switch off all electrical components.
- Switch ignition off and remove ignition key.
- Reach from bottom into recesses into recesses at Climatronic Control Module J255 (control head).
- Pull Climatronic Control Module J255 (control head) out of mounting frame - arrows -.
- Put Climatronic Control Module J255 (control head) down on center console on rag to prevent surfaces from damage.
- Disconnect electrical harness connectors in sequence - A D - by releasing catches - F -.
- Disconnect electrical harness connector - E -.
- Remove gap cover above ashtray - arrow -.
- Open front ashtray.
- Remove insert of front ashtray.
- Remove bolts - 1 - and - 2 -.
- Release ashtray - 3 - using a screwdriver - arrow -, attach screwdriver at opening - 4 - to do so.
- Remove housing of front ashtray.
- Disconnect electrical harness connector.
- Release retaining wedge - 2 - in - direction of arrow - and remove ashtray illumination - 1 - toward rear.
Installing
Installation is performed in reverse order of removal, noting the following:
- Slide ashtray illumination into mount until retaining wedge engages.
Tightening torque
| Component | Nm |
| Ashtray housing to front center console frame | 3 |