Compression Pressure, Checking: Procedure: Assembling

Tightening Specification. Refer to OVERVIEW - CYLINDER HEAD .

Assemble in reverse order of disassembling. Note The Following:

NOTE:

Secure All Hose Connections With Hose Clamps Of The Same Type As Those Equipped By The Factory.

-- Install the spark plugs. Refer to appropriate service information.

-- Install the air filter housing. Refer to OVERVIEW - AIR FILTER HOUSING .

-- If the engine was started while the electrical connectors were disconnected, then the following fault is stored in the engine control module: "generate readiness code" in "Guided Functions " using the Vehicle Diagnostic Tester.