Installing Shaft Seal

Fig 1: Installing Shaft Seal Using T40239

Courtesy of AUDI OF AMERICA, LLC

-- Coat the outer edge of the shaft seal with transmission fluid.

-- Install the shaft seal using the thrust piece, -1- from the T40239 up to the end stop. Do not bend the seal.

-- Fill the space between the sealing and dust lip half way with sealing grease G 052 128 A1.

-- Install the transmission output shaft into the center differential housing as follows:

Fig 2: Installing Flange Shaft

Courtesy of AUDI OF AMERICA, LLC

-- Install the transmission output shaft into the center differential housing from underneath.

-- Position the housing and transmission output shaft on the VW 402 under the shop press.

-- Mount the 30 - 100 on the ball bearing inner race.

-- Install the transmission output shaft.

-- Install the locking ring -arrow- into the groove on the transmission output shaft.

Fig 3: Circlip On Inner Side Of Cover, Removal/Installation

Courtesy of AUDI OF AMERICA, LLC

-- Install the center differential and housing CENTER DIFFERENTIAL, TRANSMISSION INSTALLED .