Headrest Guide, Removing And Installing, Standard/Sport Seat: Installing

WARNING:

Follow all Safety Precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS .
Before handling pyrotechnic components (for example, connecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.

Install In Reverse Order Of Removal. Note The Following:

Headrest Guide Without Release Button:

Fig 1: Headrest Guide Without Release Button

Courtesy of AUDI OF AMERICA, LLC

NOTE:

When sliding the headrest guide -1- in, make sure the tab -3- engages correctly on the backrest frame -2-.

Make sure the retaining tabs -arrows- are engaged in the backrest frame -2- correctly.

Headrest Guide With Release Button:

Fig 2: Headrest Guide With Release Button

Courtesy of AUDI OF AMERICA, LLC

NOTE:

When Sliding The Headrest Guide -1- In, Make Sure The Tab -3- Engages Correctly On The Backrest Frame -2-.

Make sure the retaining tabs -arrows- are engaged in the backrest frame -2- correctly.

Continuation For Headrest Guide Without And With Release Button

NOTE:

Make Sure The Connectors Are Installed Correctly And Are Secure.

WARNING:

Ignition Must Be On When Connecting Battery. If Pyrotechnic Components (For Example, Airbag, Belt Tensioner) Are Not Repaired Correctly, They May Deploy Unintentionally After Connecting Battery. There Must Not Be Anyone Inside The Vehicle When Connecting The Battery.

-- Connect the battery ground cable with the ignition turned on. Refer to BATTERY, DISCONNECTING AND CONNECTING .

NOTE:

If The Airbag Indicator Lamp -K75- Indicates A Fault, Check The DTC Memory, Erase It And Check It Again Vehicle Diagnostic Tester.