LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2008 >> A5 Standard >> Repair and Diagnosis >> Accessories & Equipment >> Seats >> SEAT FRAMES (1 Of 2) (COUPE) >> 72 Seat Frames >> Front Seats >> Entry Assistance Connecting Cable, Removing And Installing >> Installing

Entry Assistance Connecting Cable, Removing And Installing: Installing

WARNING:
  • Follow all Safety Precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS .
  • Before handling pyrotechnic components (for example, connecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.

Install In Reverse Order Of Removal. Note The Following: 

NOTE:

Make Sure The Connectors Are Installed Correctly And Are Secure.

WARNING:

Ignition Must Be On When Connecting Battery. If Pyrotechnic Components (For Example, Airbag, Belt Tensioner) Are Not Repaired Correctly, They May Deploy Unintentionally After Connecting Battery. There Must Not Be Anyone Inside The Vehicle When Connecting The Battery.

-- Connect the battery ground cable with the ignition turned on. Refer to BATTERY, DISCONNECTING AND CONNECTING .

NOTE:

If The Airbag Indicator Lamp -K75- Indicates A Fault, Check The DTC Memory, Erase It And Check It Again Vehicle Diagnostic Tester.

scientia non olet · About LEMON Manuals