Distance Regulation Control Module Clip, From My 12

NOTE:

If The Stud Bolt Is Being Removed, Then The Clip Must Always Be Replaced.

The Clip Will Get Damaged When It Is Being Removed.

The Adaptive Cruise Control Sensor -G550- Is Removed And The Nuts Are Removed Form The Stud Bolts.

-- Remove The Stud Bolt -1- With A Suitable Tool -2-.

Fig 1: Identifying Stud Bolt Removal With Suitable Tool

Courtesy of AUDI OF AMERICA, LLC

-- Place A Screwdriver Between The Hook And The Housing.

Fig 2: Place A Screwdriver Between Hook And Housing

Courtesy of AUDI OF AMERICA, LLC

-- Using The Screwdriver, Bend The Hook To The Center Point Until It Audibly Breaks Off.

-- To Prevent The Broken Hooks From Getting Caught On The Housing, Remove Them Using Needle Nose Pliers.

-- Remove The Clip With Needle Nose Pliers As Illustrated.

-- Insert The New Clip Into The Hole For The Housing From The Left Side And Push It In By Hand Until It Audibly Engages.

Fig 3: Insert New Clip Into Hole For Housing From Left Side And Push It In By Hand Until It Audibly Engages

Courtesy of AUDI OF AMERICA, LLC

-- Mount The Stud Bolt Making Sure Is It Parallel To The Hole.

-- The Stud Bolt Can Be Tighten Once Is It Correctly Aligned.

-- Install The Stud Bolt Until The Dimension -A- Is Reached.

Fig 4: Identifying Dimension -A- To All Studs

Courtesy of AUDI OF AMERICA, LLC

Dimension -a- = 43.3 mm

-- Repeat This On The Other Clips.