Adjustment Procedure Using Acc Setting Device:Vas 6190: Notes
Special Tools And Workshop Equipment Required
- Vehicle Diagnosis, Testing And Information System:VAS 5051 A
- Diagnostic Cable:VAS 5051/5A
- ACC Adjustment Device:VAS 6190
- Adjustment Tool:VAS 6190/2
- Wheel Alignment Computer
The :VAS 6190 May Have To Be Adapted For The Adjustment Procedure. Refer To ACC Setting Device .
Before Driving The Vehicle Onto The Alignment Stand, Check Whether There Is A Sufficiently Large Space Between The Vehicle And The :VAS 6190 . The Distance Between The :VAS 6190 And The Vehicle Must Be 120 cm +/- 5 cm.
If There Is Not Sufficient Space, Drive Vehicle Backward On Alignment Stand In Order To Be Able To Use The Corresponding Space.
- Before Beginning The Adjustment, Check The DTC Memory And Correct Any Malfunctions Present.
The Adjustment Procedure Is Described Here With The :VAS 6190 . However the ADC test fixture:VAS 6041 And ADC Reflector Mirror:VAS 6041/1 Can Also Be Used.
If There Was A Previous Axle Alignment, The Steps Under "Calibration Procedure Without A Previous Axle Alignment" Should Not Performed.