Preparation Work For Calibrating And Adjusting Driver Assist Systems

Perform The Following Work, If A Vehicle Calibration/Adjustment On One Or Several Driver Assist Systems Via "Quick Access" Is Being Performed (Without A Previous Wheel Alignment):

• Before Driving The Vehicle Onto The Alignment Stand, Check Whether There Is A Sufficiently Large Space Between The Vehicle And The ACC Adjustment Device. Distance Between The Setting Device And The Vehicle: 120 cm +/- 2.5 cm.
• If There Is Not Sufficient Space, Drive Vehicle Backward On Alignment Stand In Order To Be Able To Use The Corresponding Space.
• Check The DTC Memory And Correct Any Malfunctions Before Beginning The Calibration/Adjusting.
• Vehicle Accurately Aligned, Suspension Bounced And Rocked Several Times
• Make Sure That The Sliding Plates And Turn Tables Are Not Touching The End Stop When Checking The Wheel Alignment.
• Refer To The Owner's Manual And Activate The Changing A Wheel Mode.
• Connect The Battery Charger. Refer To BATTERY, CHARGING WITH BATTERY CHARGER :VAS5900 .
• Position The Front Wheels So They Are Straight.
• Connect The Vehicle Diagnosis Tester To The Vehicle And Guide The Diagnostic Cable Through The Open Window.
• The Vehicle Exterior Lamps Are Off.
• All The Vehicle Doors Are Closed.
• Using The Screen, Turn On The Calibration/Adjustment On The Wheel Alignment Computer.