Level Control System Sensor: Installing
Install in reverse order of removal. Note the following:
Only sensors of the same version may be installed.
Tightening specifications, refer to TRACK CONTROL ARM, BALL JOINT, GUIDE LINK AND LEVEL CONTROL SYSTEM SENSOR OVERVIEW .
Guide the retaining hook on the sensor bracket into the subframe.
The sensor lever must point toward the back.
After loosening, check basic setting of headlamp adjustment. .
-- If the vehicle level sensor was removed and installed on a vehicle with electronically controlled damping or if the linkage was loosened, the control position must be reprogrammed. Refer to CONTROL POSITION, PROGRAMMING USING VEHICLE DIAGNOSTIC TESTER .
-- If the control position was reprogrammed on vehicles with lane assist, the directional stabilization assistance control module -J759- must be recalibrated. Refer to LANE ASSIST CALIBRATION PROCEDURE .