Rear seat child seat anchorage (Sedan)

WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2008 Audi S4, 2008 Audi RS 4, 2008 Audi A4, 2007 Audi S4, and 2007 Audi RS 4. However, it is still accessible from the selected car via links, so may be relevant.

Special tools, testers and auxiliary items required

Fig 1: Identifying Torque Wrench V.A.G. 1331

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Torque wrench V.A.G 1331

NOTE:

Mounts for 3 child seat anchorages can be installed.

Fig 2: Rear Seat Child Seat Anchorage (Sedan) Remove/Install Components

Courtesy of VOLKSWAGEN UNITED STATES, INC.

Remove rear shelf → Rear shelf, removing and installing .

1 - Pop rivet

Qty. 3 per plate
For securing threaded washer - 2 - to plate

NOTE:

The threaded plate must always be installed from below (luggage compartment side)

2 - Threaded plate

Threaded insert points upward

3 - Cover cap

To install, position rear and press front down (symbol faces toward front).

4 - Screw

Tightening torque 23 Nm

5 - Anchorage

6 - Spacer sleeve