Heater And A/C Unit, Removing And Installing: Notes
WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Cooling System Tester VAG1274B (and corresponding adapters)
- Hose Clamps - Up To 25mm 3094 and Hose Clamps - Up To 40mm 3093
- Commercial compressed-air gun with rubber end piece
NOTE:
When removing, record the bolt lengths and allocation reinstallation.
All cable ties and other wiring harness fasteners released or cut open on removing air conditioner unit are to be re-attached in same position on installation.