Condensation Water Drain, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition.

-- Remove the luggage compartment floor covering. Refer to LUGGAGE COMPARTMENT TRIM PANELS .

-- Bring the battery cooling module in the service position. Refer to BATTERY COOLING MODULE, BRINGING INTO SERVICE POSITION .

-- Remove the nuts -2- and -3- and move the heat shield slightly to the left.

Fig 1: Unlocking Plastic Ring And Push Condensation Water Drain Into Battery Cavity

Courtesy of AUDI OF AMERICA, LLC

-- Unlock the plastic ring -arrows- and push the condensation water drain into the battery cavity.

-- Remove the condensation water drain from the bracket.