Removing and Installing:

WARNING: This page does not describe the selected car, but rather 18 other vehicles, including the 2016 Audi S4, 2016 Audi A4 Quattro, 2016 Audi A4, 2015 Audi S4, and 2015 Audi A4 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition.

-- Remove the upper lock carrier cover. Refer to OVERVIEW - LOCK CARRIER and LOCK CARRIER COVER, REMOVING AND INSTALLING .

-- Disconnect the connector -E- on the temperature sensor -A- and remove the temperature sensor from the bracket (-B- or -D-).

NOTE:

Depending on the vehicle equipment level, it may be necessary to remove the bumper in order to remove the Outside Air Temperature Sensor -G17- -A- from the bracket -C- installed under the impact member -D- (if, for example, the Outside Air Temperature Sensor -G17- is not accessible from above on vehicles with additional radiators).

-- After installing, check the DTC memory for the Climatronic Control Module -J255- display and control head (and the Instrument Cluster Control Module -J285-) and erase any faults, if necessary using the Vehicle Diagnostic Tester in the "Guided Fault Finding " function.