Overview - Rollover Protection: Notes
WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
- Loosen only those bolts shown in the illustration.
- Never remove the support plates from the rollover protection.
- Bolt
- 23 Nm
- Quantity: 6
- If it was removed because of an accident, replace the bolt
- Tightening sequence. Refer to Figure.
- Bracket
- For the connector
- Removing and Installing. Refer to CONNECTOR BRACKET, REMOVING AND INSTALLING .
- Bolt
- 23 Nm
- Quantity: 4
- If it was removed because of an accident, replace the bolt
- Tightening sequence. Refer to Figure.
- Bolt
- 23 Nm
- Quantity: 4
- If it was removed because of an accident, replace the bolt
- Tightening sequence. Refer to Figure.
- Pop Rivet Nuts
- Quantity: 6
- Removing and Installing. Refer to REAR HEADREST POP RIVET NUT, REMOVING AND INSTALLING .
- Trim
- Quantity: 2
- Clipped to the rollover protection
- Removing and Installing. Refer to ROLLOVER SUPPORT TRIM, REMOVING AND INSTALLING .
- Rollover Protection
- Rollover protection shown in its extended position
- Removing and Installing. Refer to ROLLOVER PROTECTION, REMOVING AND INSTALLING .
- Measure in the body. Refer to ROLLOVER PROTECTION IN BODY, ALIGNING .
- Guide
- Inserted in the rollover support
- Removing and Installing. Refer to ROLLOVER SUPPORT GUIDE, REMOVING AND INSTALLING .
- Bolt
- 23 Nm
- Quantity: 4
- If it was removed because of an accident, replace the bolt
- Tightening sequence. Refer to Figure.
- Bolt
- 23 Nm
- Quantity: 4
- Pre-assembled loosely in the original part
- If it was removed because of an accident, replace the bolt
- Tightening sequence. Refer to Figure.
- Adjusting Screw
- For the side trim panel
- Bolt
- 23 Nm
- Quantity: 4
- If it was removed because of an accident, replace the bolt
- Tightening sequence. Refer to Figure.