Component Location Overview - Passenger Occupant Detection System
WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
The replacement part (service kit) for the passenger occupant detection system is already precalibrated and must not be separated under any circumstances. The service kit consists of:
- Passive Occupant Detection System Control Module - J706
- Passive Occupant Detection System Pressure Sensor - G452
- Passenger Occupant Detection System Mat
- Seat Cushion
- Wiring Harness between Passive Occupant Detection System Control Module -J706 and Passive Occupant Detection System Pressure Sensor -G452.
WARNING:
Follow all safety precautions when working on the passenger occupant detection system. Refer to ADDITIONAL SAFETY PRECAUTIONS - PASSENGER OCCUPANT DETECTION SYSTEM DEACTIVATION, MARKET-SPECIFIC .
NOTE:
The passenger occupant detection system is only installed in the front passenger seat.
- Passenger Occupant Detection System Pressure Sensor -G452-
- Component of the passenger occupant detection system mat -item 6-
- Removing and Installing. Refer to PASSENGER OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .CAUTION:
Do not disconnect the connector.
- Seat Pan
- Clip
- Cushion
- For the seat pan
- Do not separate from the passenger occupant detection system mat -6-
- Clip
- Do not release.
- Mat
- For the passenger occupant detection system
- Component with the Passenger Occupant Detection System Pressure Sensor -G452-
- Do not disconnect from the seat pan cushion -4-
- Removing and Installing. Refer to PASSENGER OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .
- Mount
- The version depends on the model
- For the Passenger Occupant Detection System Control Module -J706-
- Expanding Pin
- For securing the mount to the seat pan
- Wiring Harness
- Do not separate from the Passenger Occupant Detection System Pressure Sensor -G452- and Passenger Occupant Detection System Control Module -J706-
- Front Passenger Seat Position Sensor -G554-
- This is a wiring harness component -9-
- Removing and Installing. Refer to SEAT POSITION SENSOR, REMOVING AND INSTALLING, EQUIPMENT WITH PASSENGER OCCUPANT DETECTION SYSTEM FOR FRONT PASSENGER AIRBAG DEACTIVATION .
- Passenger Occupant Detection System Control Module -J706-
- The version depends on the model
- Removing and Installing. Refer to PASSENGER OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .CAUTION:
Do not disconnect the connector.
- Bolt
- 1.5 Nm