LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2008 >> A5 Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1374 (Passenger Protection, Airbags, Seat Belts (Cabriolet)) >> 69 Passenger Protection, Airbags, Seat Belts >> Airbag Control Module >> Airbag Control Module -J234-, Removing And Installing >> Installing

Airbag Control Module -J234-, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
  • Follow all safety precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS .
  • Before handling pyrotechnic components (for example, connecting a connector), the person handling it must "discharge static electricity". For example, this can be done by briefly touching the door striker.

Install in reverse order of removal and Note The Following: 

NOTE:

Make sure the connectors are installed all the way and engage audibly.

WARNING:

The ignition must be on when connecting the battery. If pyrotechnic components (for example, airbag, belt tensioner) are not repaired correctly, they may deploy unintentionally after connecting battery. There must not be anyone in the vehicle interior when connecting the battery.

-- Connect the battery ground cable with the ignition switched on. Refer to BATTERY .

NOTE:

If the Airbag Indicator Lamp -K75- indicates a fault after installing, check the DTC memory, erase it and check it again using the Vehicle Diagnostic Tester.

The Airbag Control Module -J234- must be coded after replacing it using the Vehicle Diagnostic Tester.

The Airbag Control Module -J234- ground connection is achieved via the housing with the body.

scientia non olet · About LEMON Manuals