RECODE Tire Pressure Monitoring Control Module -J502-.
WARNING: This page does not describe the selected car, but rather 19 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
The Tire Pressure Monitoring Control Module -J502- must be coded if it is replaced. To do this, proceed as follows.
-- Connect the Vehicle Diagnostic Tester and then perform vehicle-specific entry into Guided Fault Finding and select "Function/component selection" using the Go To button.
-- Select the corresponding program in "Guided Functions".
-- Follow the prompts on the screen.